Photo Electric Street Light
By Bill Bowden
This is basically a Schmitt Trigger circuit which receives input from a cadmium sulfide photo cell and controls a relay that can be used to switch off and on a street lamp at dawn and dusk. I have built the circuit with a 120 ohm/12 volt relay and monitored performance using a lamp dimmer, but did not connect the relay to an outside light.
The photo cell should be shielded from the lamp to prevent feedback and is usually mounted above the light on top of a reflector and pointed upward at the sky so the lamp light does not strike the photo cell and switch off the lamp.
The photo cell is wired in series with a potentiometer so the voltage at the junction (and base of transistor) can be adjusted to about half the supply, at the desired ambient light level. The two PNP transistors are connected with a common emitter resistor for positive feedback so as one transistor turns on, the other will turn off, and visa versa. Under dark conditions, the photo cell resistance will be higher than the potentiometer producing a voltage at Q1 that is higher than the base voltage at Q2 which causes Q2 to conduct and activate the relay.
The switching points are about 8 volts and 4 volts using the resistor values shown but could be brought closer together by using a lower value for the 7.5K resistor. 3.3K would move the levels to about 3.5 and 5.5 for a range of 2 volts instead of 4 so the relay turns on and off closer to the same ambient light level. The potentiometer would need to be readjusted so that the voltage is around 4.5 at the desired ambient condition.
3823 05 August 2007
The LED traffic Light circuit controls 6 LEDs (red, yellow and green) for both north/south directions and east/west directions.
This circuit came from a 14 Watt Commercial Electric spiral bulb from Home Depot. In fact, I drew it in that way because it was layed out very well, so much credit should go to Sam Goldwasser.
Here is the schematic of another fluorescent ballast circuit from a lamp I acquired along with the 80W electronic ballast. It actually contains a pair of the circuit in the diagram, one for each bulb.
Apostille birth certificate. Apostille services. Providing document authentications.